Hyundai Equus: Auto Defogging Sensor Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / Auto Defogging Sensor Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / Auto Defogging Sensor Description and Operation
| Description |
The auto defogging sensor is installed on the front window
glass. The sensor judges and sends signal if moisture occurs to blow out
wind for defogging. The air conditioner control module receives signal
from the sensor and restrains moisture and eliminate defog by
controlling the intake actuator, A/C, auto defogging actuator, blower
motor rpm, and mode actuator.
Air Quality Sensor (AQS) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Connect the GDS.
3.
Check the output voltage of AQS between terminal 2 and 3.
1. DC 12V( Ignition)2. Sensor ground3. AQS signal
Specif ...
Auto Defogging Sensor Repair procedures
Inspection
To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remov ...
See also:
Hood Insulator Pad Repair procedures
Replacement
1.
Using a clip remover, detach the clips, and remove the hood insulator pad (A).
•
Be careful not to scratch the hood panel.
2.
Installation is th ...
Repair procedures
Replacement
1.
Disconnect the battery negative cable from the battery and then wait for at least 30 seconds.
2.
Turn the steering wheel so that the front wheels can face straight ahead.
3.
...
Rear Glass Defogger Relay Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear glass defogger relay (A) from the engine room relay box.
3.
There should be continuity between the No.87 and ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com