>

Hyundai Equus: Auto Defogging Sensor Repair procedures - Air Conditioning System - Heating, Ventilation and Air Conditioning - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Auto Defogging Sensor Repair procedures

Inspection
To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the inside rearview mirror cover (A).

3.
Disconnect the connector (A) and then remove the auto defogging sensor (B).

4.
Install in the reverse order of removal.
    Auto Defogging Sensor Description and Operation
    Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control m ...

    Cluster Ion Generator Description and Operation
    Description The cluster ion generator makes disinfection and decomposition of bad smell from the air-conditioner or inflow air. And it cleans the inside air of a vehicle. When the ignition swi ...

    See also:

    Components and Components Location
    Components [Sunroof Type] 1. Roof trim2. Sunvisor [RH]3. Sunvisor [LH]4. Assist handle bracket [Limousine Type] 1. Roof trim2. Sunvisor [RH]3. Sunvisor [LH]4. Assist handle bracket ...

    Underdrive Brake Control Solenoid Valve(UD/B_VFS) Repair procedures
    Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the res ...

    Recalling Position into Memory
    1. Check that the shift lever is in P (Park) and the Engine Start/Stop Button is in the ON position. 2. Press the desired memory button (1 or 2). The system will beep once, then the driver's ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com