Hyundai Equus: Automatic Transmission Components and Components Location
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission System / Automatic Transmission Components and Components Location
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission System / Automatic Transmission Components and Components Location
| Components Location |
| 1. Automatic transmission case 2. Inhibitor switch 3. Manual control lever 4. Shift cable bracket 5. Oil injection hole 6. Air breather hose & pipe | 7. Oil injection hole (in factory) 8. E Module connector 9. Support bracket 10. Check plug 11. Oil cooler port |
Repair procedures
EOL Input
Description
When shift shock is occurred or parts related with the transmission are replaced, EOL should be performed.
In the following case, EOL is required.
•
Transmission ass ...
Automatic Transmission Repair procedures
Removal
1.
Disconnect (-) terminal from the battery.
The battery is placed right side of the temporary tire in the trunk.
2.
Remove the under cover (A).
3.
Remove ...
See also:
Brake Line Repair procedures
Removal
1.
Remove the wheel & tire.
2.
Remove the brake hose clip (A).
Front
Rear
3.
Disconnect the brake tube by loosening the tube flare nut.
Tightening torque :
12.7 ~ 16.7 N ...
Delivery Pipe Repair procedures
Removal
In case of removing the high pressure fuel pump, high
pressure fuel pipe, delivery pipe, and injector, there may be injury
caused by leakage of the high pressure f ...
MTS Antenna Components and Components Location
Components
...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com