Hyundai Equus: Battery Sensor Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Electrical System / Charging System / Battery Sensor Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Electrical System / Charging System / Battery Sensor Repair procedures
| Removal |
| 1. |
Disconnect the battery negative (-) cable. |
| 2. |
Disconnect the battery sensor connector (A). |
| 3. |
Remove the battery negative (-) cable after removing the bolts (B).
|
| Installation |
| 1. |
Install in the reverse order of removal.
|
Battery Sensor Description and Operation
Description
Vehicles have many control units that use more electricity.
These units control their own system based on information from diverse
sensors. It is important to have a stable power s ...
Starting System
...
See also:
Transmission Oil Temperature Sensor Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Compressor Description and Operation
Description
The compressor is the power unit of the A/C system.
It is located on the side of engine block and driven by a V-belt of the engine.
The compressor changes low pressure and low tempera ...
Smart Cruise Control Switch Schematic Diagrams
Circuit Diagram
...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com