>
Hyundai Equus Manuals

Hyundai Equus: A/C Pressure Transducer Repair procedures - Air Conditioning System - Heating, Ventilation and Air Conditioning - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: A/C Pressure Transducer Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / A/C Pressure Transducer Repair procedures

Inspection
1.
Measure the pressure of high pressure line by measuring voltage output between terminal “1” and “2”.

2.
Inspect the voltage value whether it is sufficient to be regular value or not.

Voltage = 0.00878835 * Pressure + 0.37081095
3.
If the measured voltage value is not wihtin specification, replace the A/C pressure transducer.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/charging station.
3.
Disconnect the A/C pressure transducer connector (A).

4.
Remove the A/C pressure transducer (A).
Tightening torque :
10 ~ 12 N.m (1.02 ~ 1.22 kgf.m, 7.4 ~ 8.8 lb-ft)

   
Be careful not to bend the liquid & suction pipe.
Support the hex portion of the pipe with a wrench while removing or installing the A/C pressure transducer.
5.
Install in the reverse order of removal.
   
When installing, replace it with a new O-ring (A).

    A/C Pressure Transducer Description and Operation
    Description The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the coolin ...

    Evaporator Temperature Sensor Description and Operation
    Description The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by excessive cooling. ...

    See also:

    Propeller Shaft Repair procedures
    Inspection CV Joint and Boots 1. Shift the transaxle to Neutral. 2. Raise the vehicle off the ground, and support it with safety stands in the proper locations. 3. Check the center beari ...

    Power Trunk Module Drive Unit Schematic Diagrams
    Circuit Diagram ...

    Pre-active Seat Belt (PSB) Description and Operation
    Description Pre-active Seat Belt (PSB) guarantees initial restraint performance by winding the seat belt right before a crash or dangerous condition and enhances the effects of the seat belt pr ...

    Categories

    Hyundai Equus Manuals

    2011-2026 Copyright www.heqmanual.com