>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the LDWS unit cover (A). |
3. |
Remove the LDWS unit connector (A). |
4. |
Remove the front side of roof trim to remove the LDWS unit mounting bolts.
(Refer to Body group - "Roof Trim") |
5. |
Remove the LDWS unit after loosening the mounting bolts. |
Installation |
1. |
Install the LDWS unit. |
2. |
Install the roof trim. |
3. |
Install the LDWS unit cover. |
4. |
Check LDWS system operation. |
Defroster
CAUTION
To prevent damage to the conductors bonded to the inside surface of the rear
window, never use sharp instruments or window cleaners containing abrasives to clean
the window.
✽ NOT ...
Air Filter Components and Components Location
Components Location
1. Air filter2. Y-Connector3. Mounting bracket
...
Inhibitor Switch Specifications
Specifications
x Type: Combination of output signals from 4 terminals
Power supply (V)12Output typeCombination of output signals
Signal Code Table
PIN No.PP-RRR-NNN-DDS112V12VO ...