>

Hyundai Equus: Auto Light Sensor Repair procedures - Auto Lighting Control System - Body Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Auto Light Sensor Repair procedures

Inspection
In the state of IGN1 ON, when the multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto light sensor's input.
If IGN1 ON, The BCM monitors the range of this supply and raises up a failure as soon as the supply’s voltage is out of range. Then this failure occurs and as long as this is present, the head lamp must be turned on without taking care about the sunlight level provided by the sensor.
This is designed to prevent any head lamp cut off when the failure occurs during the night.
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rain sensor.
(Refer to Windshield Wiper/Washer - "Rain Sensor")
Installation
1.
Install the rain sensor.
2.
Connect the negative (-) battery terminal.
    Description and Operation
    Description In the state of IGN1 ON, when the multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to the ve ...

    Head lamp leveling Device
    ...

    See also:

    Troubleshooting
    Troubleshooting SymptomPossible causeRemedyOne lamp does not light(all exterior)Bulb or LED burned outReplace bulb or lamp assemblySocket, wiring or ground faultyRepair if necessaryHead lamps do ...

    Yaw-rate and Lateral G Sensor Repair procedures
    Replacement 1. Turn ignition switch OFF and disconnect the negative (-) battery cable 2. Remove the floor console. (Refer to Body - "Console") 3. Disconnect the yaw rate & lateral G s ...

    Inhibitor Switch Description and Operation
    Description Inhibitor Switch monitors the lever's position(PRND) and is used to control gear setting signals. ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com