>
Hyundai Equus Manuals

Hyundai Equus: Front Door Module Repair procedures - Front Door - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Front Door Module Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Front Door / Front Door Module Repair procedures

Replacement
1.
Remove the front door window glass.
(Refer to Front Door - "Front Door Window Glass")
2.
Remove the front door outside handle.
(Refer to Front Door - "Front Door Outside Handle")
3.
Loosen the front door outside handle base mounting screw (A).

4.
Using a screwdriver or remover, remove the extension cover (A).

5.
Disconnect the outside rear view mirror connector (A).

6.
Loosen the front door latch (B) mounting screws.
7.
After loosening the mounting bolts, then remove the front door module (A).
Tightening torque :
(A) : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
(B) : 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

8.
Disconnect the connectors (A) and front door module wiring harness (B) from the front door module.

9.
Install in the reverse order of removal.
   
•
The area of whole parts should be applied with sufficient grease.
•
Make sure connectors are connected properly and each rod is connected securely.
•
Make sure the door locks/unlocks and opens/closes properly
    Front Door Module Components and Components Location
    Component Location 1. Front door module ...

    Front Door Outside Handle Components and Components Location
    Component Location 1. Front door outside handle ...

    See also:

    Front seat adjustment
    The front seat can be adjusted by using the control switches located on the doors. Before driving, adjust the seat to the proper position so as to easily control the steering wheel, pedals and swi ...

    Inhibitor Switch Repair procedures
    Inspection     • Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Power Circuit Inspection ...

    Auto Head lamp leveling Unit Repair procedures
    Removal 1. Remove the head lamp leveling unit linkage (A) from trailing arm. 2. Loosen the mounting bolts (3EA) of automatic head lamp leveling unit assembly. Tightening torque : 3 ~ 5 N.m ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com