Hyundai Equus: High Mounted stop lamp Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Lighting System / High Mounted stop lamp Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Lighting System / High Mounted stop lamp Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the rear package trim (A).
(Refer to Body - "Interior trim")
|
| 3. |
Remove the high mounted stop lamp (A) after removing screws.
|
| Installation |
| 1. |
Install the high mounted stop lamp to the rear package trim. |
| 2. |
Install the rear package trim. |
Front Fog Lamps Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front bumper.
(Refer to Body - "Bumper")
3.
Remove the front fog lamp assembly (A) after loosening screws.
Install ...
Troubleshooting
Troubleshooting
SymptomPossible causeRemedyOne lamp does not light(all exterior)Bulb or LED burned outReplace bulb or lamp assemblySocket, wiring or ground faultyRepair if necessaryHead lamps do ...
See also:
Rear Pillar Trim Components and Components Location
Component Location
1. Rear pillar trim
...
Rear Stabilizer Bar Repair procedures
Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
•
Be careful not to damage ...
Hood Lift Repair procedures
Replacement
•
When removing and installing the hood lifter, an assistant is necessary.
•
When removing the clips, use a clip remover.
1.
Using a screwdrive ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com