>

Hyundai Equus: Power Latch Repair procedures - Power Trunk Module - Body Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Power Latch Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the trunk trim in the trunk.
(Refer to Body - "Trunk")
3.
Remove the power latch (A) after removing the bolts (2EA) and connector (B).

Installation
1.
Install the power latch and connector.
2.
Install the trunk trim.
3.
Connect the negative (-) battery terminal and check the power trunk module correctly.
Inspection
Power Trunk Lid Inspection With GDS
1.
Check the power trunk module input/output value by using the GDS. If the operation of power trunk module is abnormal, replace power trunk drive unit.
2.
To check the DTC of the power trunk module, select "PTM"
3.
Select "Input/output monitoring".

    Power Trunk Module Drive Unit Repair procedures
    Removal     • When removing and installing the trunk lid, an assistant is necessary. • Take care not to be closed the trunk when removing the push rod. • Wear ...

    Power Striker Repair procedures
    Inspection Power Trunk Lid Inspection With GDS 1. Check the power trunk module input/output value by using the GDS. If the operation of power trunk module is abnormal, replace power trunk dri ...

    See also:

    Presure Switch Specifications
    Specifications Specifications (20°C(68°F))OFF => ON146 ± 40 kPaON => OFF50 kPa ...

    Good driving practices
    Never move the gear shift lever from P (Park) or N (Neutral) to any other position with the accelerator pedal depressed. Never move the gear shift lever into P (Park) when the vehicle is in mo ...

    Engine compartment fuse replacement
    1. Turn the ignition switch and all other switches off. 2. Remove the fuse panel cover by pressing the tab and pulling up. 3. Check the removed fuse; replace it if it is blown. To remove or insert ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com