>

Hyundai Equus: Windshield Deicer Repair procedures - Windshield Deicer - Body Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Windshield Deicer Repair procedures

Inspection
1.
Remove the cowl top cover (A).
(Refer to Body - "Wiper")

2.
Disconnect the windshield deicer connector (A) from the wiper motor linkage.

3.
Check for continuity between the terminals of deicer lines.

4.
Turn the ignition switch ON and the windshield deicer switch ON, then measure the voltage between the terminals of harness side deicer connector.

OK: approx. Battery voltage

    Description and Operation
    Description Windshield deicer system prevent windshield wiper from freezing in the winter season. It consists of deicer in the lower part of windshield, switch and relay. Body control module re ...

    Windshield Deicer Switch Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or plastic panel remover, remove the cluster fascia upper panel (A). 3. Using a screwdriver or plastic panel ...

    See also:

    Fuel Pump Control Module (FPCM) Description and Operation
    Description The fuel pump control module (FPCM) is installed on the right side of the trunk compartment. It controls the BLDC (Brushless DC) motor mounted inside the variable low pressure fuel ...

    Rear Seat Belt Buckle Repair procedures
    Replacement [Sedan 6:4] 1. Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly") 2. Loosen the mounting bolt, and then remove the rear seat belt buckle (A). [L ...

    Front Seat Frame Assembly Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply p ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com