Hyundai Equus: Spliter Unit Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Premium AVN System / Spliter Unit Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Premium AVN System / Spliter Unit Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the floor console.
(Refer to Body - "Floor Console Assembly") |
| 3. |
Remove the spliter unit (A) after disconnecting the connectors and loosening the mounting bolts.
|
| Installation |
| 1. |
Install the spliter unit after connecting connector.
|
| 2. |
Install the floor console. |
| 3. |
Connect the negative (-) battery terminal and then check to operate the rear monitor. |
Spliter Unit Description and Operation
Description
The spliter unit receive the LVDS signal from AVN head unit and send it to left/right rear monitor.
(LVDS : Low Voltage Differential Signaling ) ...
Mic Repair procedures
Removal
1.
Remove the hands free mic (A) from the roof trim.
Installation
1.
Install the hands free mic after connecting the mic connector.
Inspection
1.
Remove the handsfree mic (A) aft ...
See also:
Rearview camera (If equipped)
The rearview camera will activate when the back-up light is ON with the ignition
switch ON and the shift lever in the R position.
This system is a supplemental system that shows behind ...
Brake Pedal Repair procedures
Removal
1.
Remove the lower crash pad.
(Refer to Body - "Crash Pad")
2.
Disconnect the stop lamp switch connector (A).
3.
Remove the mounting bracket nut (B).
Tightening torque :
14. ...
Record your key number
The key code number is stamped on the key code tag attached to the key set. Should
you lose your keys, this number will enable an authorized EQUUS dealer to duplicate
the keys easily. Remove the ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com