Hyundai Equus: Damper Clutch Control Solenoid Valve Description and Operation
Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Damper Clutch Control Solenoid Valve Description and Operation
Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Damper Clutch Control Solenoid Valve Description and Operation
| Description |
Damper Clutch control solenoid valve is attached to the valve
body. This variable force solenoid valve directly controls the
hydraulic pressure inside the Damper Clutch.
Line Pressure Control Solenoid Vale Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Damper Clutch Control Solenoid Valve Specifications
Specifications
Damper Clutch Control VFS
x Control type : Normal low type
Control Pressure kpa (kgf/cmx, psi)0~500.14 (0~5.1,0~72.54)Current value(mA)0~850 Internal resistance( ...
See also:
Cluster Ion Generator Repair procedures
Inspection
1.
Press the MODE switch more then 4 times within 2 seconds while pressing the OFF switch.
DisplayFail description00Normal51Cluster ion generator fault
* For diagnostic procedur ...
Heater Core Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater and blower assembly.
(Refer to Heater -"Heater Unit")
3.
Remove the heater core cover (A) after loosening ...
Erasing HomeLink® buttons
Individual buttons cannot be erased. However, to erase all three programmed buttons:
1. Press and hold the two outer HomeLink® buttons until the indicator light begins
to flash after 10 seconds.
...
Categories
Hyundai Equus Manuals
© 2011-2025 Copyright www.heqmanual.com