Hyundai Equus: Line Pressure Control Solenoid Vale Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Line Pressure Control Solenoid Vale Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Line Pressure Control Solenoid Vale Repair procedures
| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Disconnect the E Module connector. |
| 3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
| 4. |
Check that the resistance is within the specification. |
Line Pressure Control Solenoid Vale Schematic Diagrams
Circuit Diagram
...
Damper Clutch Control Solenoid Valve Description and Operation
Description
Damper Clutch control solenoid valve is attached to the valve
body. This variable force solenoid valve directly controls the
hydraulic pressure inside the Damper Clutch. ...
See also:
Troubleshooting
Basic Troubleshooting
Basic Troubleshooting Guide
Customer Problem Analysis Sheet
Basic Inspection Procedure
Measuring Condition of Electronic Parts' Resistance
The measured resistance at high ...
Blind spot detection system (BSD) (If equipped)
The BSD (Blind spot detection) system uses a radar sensor to alert the driver
while driving.
It senses the rear side territory of the vehicle and provides information to
the driver.
(1) BSD (B ...
Radiator Repair procedures
Inspection
Radiator Cap Testing
1.
Remove the radiator cap, wet its seal with engine coolant, then install it to pressure tester.
2.
Apply a pressure of 93 ~ 123kPa (0.95 ~ 1.25kgf/cmx, 14 ~ ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com