Hyundai Equus: Windshield Deicer Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Windshield Deicer / Windshield Deicer Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Windshield Deicer / Windshield Deicer Repair procedures
| Inspection |
| 1. |
Remove the cowl top cover (A).
(Refer to Body - "Wiper")
|
| 2. |
Disconnect the windshield deicer connector (A) from the wiper motor linkage.
|
| 3. |
Check for continuity between the terminals of deicer lines.
|
| 4. |
Turn the ignition switch ON and the windshield deicer switch
ON, then measure the voltage between the terminals of harness side
deicer connector.
|
Description and Operation
Description
Windshield deicer system prevent windshield wiper from
freezing in the winter season. It consists of deicer in the lower part
of windshield, switch and relay. Body control module re ...
Windshield Deicer Switch Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or plastic panel remover, remove the cluster fascia upper panel (A).
3.
Using a screwdriver or plastic panel ...
See also:
Crach Pad Center Panel Components and Components Location
Component Location
1. Crash pad center panel
...
Schematic Diagrams
Circuit Diagram
...
Fuel Tank Pressure Sensor (FTPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification: Refer to "Specification"
Removal
1.
Turn the ignition swit ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com