>

Hyundai Equus: Vehicle break-in process - Introduction - Hyundai Equus 2009-2024 Owners ManualHyundai Equus: Vehicle break-in process

No special break-in period is needed. By following a few simple precautions for the first 600 miles (1,000 km) you may add to the performance, economy and life of your vehicle.

  • Do not race the engine.
  • While driving, keep your engine speed (rpm, or revolutions per minute) between 2,000 rpm and 4,000 rpm.
  • Do not maintain a single speed for long periods of time, either fast or slow. Varying engine speed is needed to properly break-in the engine.
  • Avoid hard stops, except in emergencies, to allow the brakes to seat properly.
  • Don't let the engine idle longer than 3 minutes at one time.
  • Don't tow a trailer during the first 1,200 miles (2,000 km) of operation.

CALIFORNIA PROPOSITION 65 WARNING

Items contained in motor vehicles or emitted from them are known to the State of California to cause cancer and birth defects or reproductive harm. These include:

  • Gasoline and its vapors
  • Engine exhaust
  • Used engine oil
  • Interior passenger compartment components and materials
  • Component parts which are subject to heat and wear In addition, battery posts, terminals and related accessories contain lead, lead compounds and other chemicals known to the State of California to cause cancer and reproductive harm.
    Fuel requirements
    Your new vehicle is designed to obtain maximum performance with UNLEADED FUEL, as well as minimize exhaust emissions and spark plug fouling. Your new vehicle is designed to use only unleaded fuel h ...

    Vehicle data collection and event data recorders
    This vehicle is equipped with an event data recorder (EDR). The main purpose of an EDR is to record, in certain crash or near crash-like situations, such as an air bag deployment or hitting a road ...

    See also:

    Driver Airbag (DAB) Module and Clock Spring Repair procedures
    Removal 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Loosen the airbag module mounting bolts (2EA). 3. Remove the wiring fixing c ...

    Manifold Absolute Pressure Sensor (MAPS) Schematic Diagrams
    Circuit Diagram ...

    Accelerator Position Sensor (APS) Repair procedures
    Inspection 1. Connect a scantool on the Data Link Connector (DLC). 2. Turn the ignition switch ON. 3. Measure the output voltage of the APS 1 and 2 at C.T and W.O.T. Specification: Refe ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com