>
Hyundai Equus Manuals

Hyundai Equus: Trunk Lid Assembly Repair procedures - Trunk Lid - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Trunk Lid Assembly Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Trunk Lid / Trunk Lid Assembly Repair procedures

Replacement
   
•
Wear gloves to protect hands from injury.
   
•
When removing and installing the trunk lid, an assistant is necessary.
1.
Remove the trunk lid trim.
(Refer to Trunk Lid - "Trunk Lid Trim")
2.
Disconnect the connectors and trunk lid wiring harness (A).
3.
After loosening the mounting bolts, then remove the trunk lid assembly (B).
Tightening torque :
21.6 ~ 26.5 N.m (2.2 ~ 2.7 kgf.m, 15.9 ~ 19.5 lb-ft)

4.
Install in the reverse order of removal.
   
•
Make sure the trunk lid locks/unlocks and opens/closes properly.
•
Adjust the trunk lid alignment.
•
Make sure the connectors are connected in properly.
•
Replace any damaged clips.
    Trunk Lid Assembly Components and Components Location
    Component Location 1. Trunk lid assembly ...

    Trunk Lid Trim Components and Components Location
    Component Location 1. Trunk lid trim ...

    See also:

    Jump starting
    Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm to yourself or damage to your vehicle or battery, follow the jump starting procedures. If in doubt, we strongly recomme ...

    Driver’s seat
    (1) Seat sliding forward or backward Seat height and cushion tilting adjustment (2) Seat cushion length adjustment (3) Seatback angle adjustment (4) Headrest height adjustment (5) Driver position ...

    Input Speed Sensor Repair procedures
    Inspection 1. Check signal waveform of Input speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com