>

Hyundai Equus: Steering Column Shroud Panel Repair procedures - Crash Pad - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Steering Column Shroud Panel Repair procedures

Replacement
[Steering column shroud lower panel]
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the crash pad lower panel.
(Refer to Crash Pad - "Crash Pad Lower Panel")
2.
After loosening the mounting screws, then remove the steering column shroud lower panel (A).

3.
Disconnect the connector (A).

4.
Install in the reverse order of removal.
   
•
Make sure the connector is connected properly.
•
Replace any damage clips.
[Steering Column Shroud Upper Panel]
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Lower the steering wheel.
2.
Using a screwdriver or remover, remove the steering column shroud upper panel (A).

3.
Install in the reverse order of removal.
   
•
Replace any damage clips.
    Steering Column Shroud Panel Components and Components Location
    Component Location 1. Steering column shroud lower panel2. Steering column shroud upper panel ...

    Crash Pad Side Cover Components and Components Location
    Component Location [LH] 1. Crash pad side cover [LH] [RH] 1. Crash pad side cover [RH] ...

    See also:

    Seat Heater Switch Repair procedures
    Removal First Seat 1. Disconnect the negative (-) battery terminal. 2. Remove the floor console upper cover. (Refer to Body - "Floor Console Assembly") 3. Remove the seat heater switch a ...

    If engine doesn't turn over or turns over slowly
    1. Be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake is set. 2. Check the battery connections to be sure they are clean and tight. 3. Turn on the interior light. If the ...

    Rear Bumper Beam Assembly Components and Components Location
    Component Location 1. Rear bumper beam assembly ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com