Hyundai Equus: Starter Relay Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Electrical System / Starting System / Starter Relay Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Electrical System / Starting System / Starter Relay Repair procedures
| Inspection |
| 1. |
Disconnect the battery negative terminal. |
| 2. |
Remove the fuse box cover. |
| 3. |
Remove the starter relay(A).
|
| 4. |
Using an ohmmeter, check that there is continuity between each terminal.
|
| 5. |
Apply 12V to terminal 85 and ground to terminal 86.
Check for continuity between terminals 30 and 87.
|
| 6. |
If there is no continuity, replace the starter relay. |
| 7. |
Install the starter relay. |
| 8. |
Install the fuse box cover. |
Starter Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the starter cable (A) from the B terminal on the solenoid, and the connector (B) from the S ter ...
See also:
Refrigerant label
The refrigerant label is located on the underside of the hood.
The label contains the following information:
Type of refrigerant
Amount of refrigerant
...
Brake Pedal Components and Components Location
Components
1. Brake pedal member assembly2. Stop lamp switch3. Clevis pin 4. Snap pin5. Brake pedal 6. Return spring7. Bolt
...
In-car Sensor Repair procedures
Inspection
1.
Turn the ignition switch ON.
2.
Blow warm air into the in-car sensor air inlet. Measure the sensor resistance between 1 and 3 terminals.
1. Sensor Ground 2. Motor (-)3. Incar ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com