Hyundai Equus: Starter Description and Operation
Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Engine Electrical System / Starting System / Starter Description and Operation
Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Engine Electrical System / Starting System / Starter Description and Operation
| Description |
The starting system includes the battery, starter, solenoid
switch, ignition switch, inhibitor switch (A/T), clutch pedal switch
(M/T), ignition lock switch, connection wires and the battery cable.
When the ignition key is turned to the start position, current flows and energizes the starter motor's solenoid coil.
The solenoid plunger and clutch shift lever are activated,
and the clutch pinion engages the ring gear.The contacts close and the
starter motor cranks.
In order to prevent damage caused by excessive rotation of
the starter armature when the engine starts, the clutch pinion gear
overruns.
In conjunction with the ISG function, the starter motor must
do a great deal more work. Therefore, the starter motor is configured
for a significantly higher number of start cycles. The components of the
starter motor have been adapted to the higher requirements.
| 1. Solenoid 2. Brush 3. Armature 4. Overrun clutch |
Troubleshooting
Troubleshooting
•
The battery must be in good condition and fully charged for this troubleshooting.
...
Starter Specifications
Specification
ItemSpecificationRated voltage12 V, 1.7 kWThe number of pinion teeth13Performance[No-load, 11.5 V]AmpereMax. 85 ASpeedMin. 2,550 rpm
...
See also:
Troubleshooting
Troubleshooting
•
Check the fuel pressure after replacing parts.
(Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line")
...
Front Air Strut Assembly Description and Operation
Description
The air spring & damper is one unit so that it is not possible to make separation.
The average pressure of front air spring is around 7.5 bar.
When the front air spring is delive ...
Auto Defogging Sensor Repair procedures
Inspection
To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remov ...
Categories
Hyundai Equus Manuals
© 2011-2025 Copyright www.heqmanual.com