>
Hyundai Equus: Seat Belt Pretensioner (BPT) Repair procedures
| Removal |
| 1. |
Disconnect the battery negative cable, and wait for at least three minutes before beginning work. |
| 2. |
Remove the safety belt (A) by turning it in the direction of arrow using a flat-head screwdriver.
|
| 3. |
Remove the center pillar lower trim.
(Refer to Body - "Center Pillar Trim") |
| 4. |
Remove the center pillar upper trim.
(Refer to Body - "Center Pillar Trim") |
| 5. |
After loosening the mounting bolt, then remove the front seat belt lower anchor (A).
|
| 6. |
Loosen the front seat belt webbing guide (A) mounting bolts.
|
| 7. |
After disconnecting the pretensioner connector lock pin,
remove the front seat belt pretensioner connectors (A), loosen the
mounting bolts, then remove the front seat belt pretensioner (B).
|
| Installation |
| 1. |
Turn the ignition switch OFF. |
| 2. |
Disconnect the battery negative cable and wait for at least three minutes. |
| 3. |
Install in the reverse order of removal. |
| 4. |
Reconnect the battery negative cable. |
| 5. |
After installing the seat belt pretensioner, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off. |
Emergency Fastening Device (EFD) Description and OperationAccelerator Position Sensor (APS) Description and Operation
Description
Accelerator Position Sensor (APS) is installed on the
accelerator pedal module and detects the rotation angle of the
accelerator pedal. The APS is one of the most important sensors ...
Tire Repair procedures
Tire Wear
1.
Measure the tread depth of the tires.
Tread depth [limit] : 1.6 mm (0.063 in)
2.
If the remaining tread (A) depth is less than the limit, replace the tire.
  ...
Rear Bumper Cover Components and Components Location
Component Location
1. Rear bumper cover
...