>
Hyundai Equus: Reprogramming a single HomeLink® button
To program a new device to a previously trained HomeLink® button, follow these steps:
1. Press and hold the desired HomeLink® button. Do NOT release until step 4 has
been completed.
2. When the indicator light begins to flash slowly (after 20 seconds), position
the handheld transmitter 1 to 3 inches away from the HomeLink® surface.
3. Press and hold the handheld transmitter button.The HomeLink® indicator light
will flash, first slowly and then rapidly.
4. When the indicator light begins to flash rapidly, release both buttons.
5. Press and hold the just-trained HomeLink® button and observe the red Status Indicator
LED. If the indicator light stays on constantly, programming is complete and your
new device should activate.
Operating HomeLink®
Erasing HomeLink® buttonsTransmission Oil Temperature Sensor Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Engine compartment
1. Engine coolant reservoir
2. Radiator cap
3. Brake fluid reservoir
4. Air cleaner
5. Engine oil dipstick
6. Engine oil filler cap
7. Windshield washer fluid reservoir
8. Fuse box
9. Power ...
Compressor Description and Operation
Description
The compressor operates in all events except the system air
filling and two solenoid valves (referred to as reverse valve, on-off
control, and normal open) are embedded.
Air dryer ...