Hyundai Equus: Reprogramming a single HomeLink® button
Second generation VI (2009–2026) / Hyundai Equus 2009-2026 Owners Manual / Features of your vehicle / Mirrors / Reprogramming a single HomeLink® button
To program a device to HomeLink® using a HomeLink® button previously trained, follow these steps:
1. Press and hold the desired HomeLink® button. DO NOT release the button.
2. The indicator light will begin to flash after 20 seconds. Without releasing the
HomeLink® button, proceed with "Programming" step 2.
Operating HomeLink®
To operate, simply press and release the programmed HomeLink® button. Activation
will now occur for the trained device (i.e. garage door opener, gate operator, security
system, entry door lock, h ...
Erasing HomeLink® buttons
Individual buttons cannot be erased. However, to erase all three programmed buttons:
1. Press and hold the two outer HomeLink® buttons until the indicator light begins
to flash after 10 seconds.
...
See also:
4&OD Clutch Control Solenoid Valve Schematic Diagrams
Circuit Diagram
...
Side impact air bag
Your vehicle is equipped with a side impact air bag in each front and outboard
rear seat. The purpose of the air bag is to provide the vehicle's driver and/or
the front and outboard rear pas ...
Fuel Tank Pressure Sensor (FTPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification: Refer to "Specification"
Removal
1.
Turn the ignition swit ...
Categories
Hyundai Equus Manuals
