Hyundai Equus: Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Fender / Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Fender / Repair procedures
| Replacement |
|
|
| 1. |
Loosen the front wheel guard mounting clip and screws.
|
| 2. |
Loosen the mounting screws and clips, remove the side sill garnish. |
| 3. |
Loosen the bumper side mounting screw, disconnect the side's bumper (A).
|
| 4. |
Loosen the mounting screws, remove the front bumper side mounting bracket. |
| 5. |
Loosen the fender mounting bolts, remove the fender (A).
|
| 6. |
Install in the reverse order of removal.
|
Components and Components Location
Component Location
1. Fender assembly
...
Hood
...
See also:
Telemetics Unit (TMU) Components and Components Location
Component
Connector Pin Information
No.DescriptionNo.Description1Ground17Battery 22Ground18Battery 13-19IGN 14Keypad ground20ACC5MIC output -21Airbag6MIC output +22Keypad input7-23-8RS422 shie ...
Receiver-Drier Repair procedures
Replacement
1.
Remove the condenser.
2.
Remove the cap (B) on the bottom of the condenser with a L wrench (A).
Tightening torque :
2.7 ~ 3.1 N.m (0.28 ~ 0.32 kgf.m, 2.0 ~ 2.3 lb-ft)
...
Trunk Lid Trim Components and Components Location
Component Location
1. Trunk lid trim
...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com