Hyundai Equus: Rear Wheel Speed Sensor Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Brake System / ESP(Electronic Stability Program) System / Rear Wheel Speed Sensor Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Brake System / ESP(Electronic Stability Program) System / Rear Wheel Speed Sensor Repair procedures
| Removal |
| 1. |
Remove the rear wheel speed sensor mounting bolt.
|
| 2. |
Remove the rear wheel guard. |
| 3. |
Disconnect the rear wheel speed sensor connector (A), then remove the rear wheel speed sensor.
|
| 4. |
Installation is the reverse of removal. |
| Inspection |
| 1. |
Measure the output voltage between the terminal of the wheel speed sensor and the body ground.
|
| 2. |
Compare the change of the output voltage of the wheel speed sensor to the normal change of the output voltage as shown below.
|
Rear Wheel Speed Sensor Components and Components Location
Components
1. Rear wheel speed sensor cable2. Rear wheel speed sensor
...
Yaw-rate and Lateral G Sensor Description and Operation
Description
The ESP system is the shorten word of Electronic Stability
Control system. This system recognizes a critical driving condition by
Yaw-rate sensor, Lateral acceleration sensor and St ...
See also:
Rear Wheel Guard Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply p ...
Blower Unit Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater and blower assembly.
(Refer to Heater - "Heater Unit")
3.
Separate the blower unit (A) from the heater un ...
Rear LCD monitor Repair procedures
Removal
Take care not to scratch the crash pad and related parts.
1.
Disconnect the negative (-) battery terminal.
2.
Remove the LCD monitor bezel (A) from the front s ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com