>

Hyundai Equus: Rear Wheel Guard Repair procedures - Body Side Molding - Body (Interior and Exterior) - Hyundai Equus VI 2009-2025 Service ManualHyundai Equus: Rear Wheel Guard Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
1.
Remove the rear tire.
2.
After loosening the mounting clips and nut, then remove the rear wheel guard (A).

3.
Install in the reverse order of removal.
   
•
Replace any damaged clips.
    Front Wheel Guard Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply p ...

    Waist Line Molding Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply p ...

    See also:

    Rear Glass Defogger Switch Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or plastic panel remover, remove the cluster fascia upper panel (A). 3. Using a screwdriver or plastic panel ...

    Rail Pressure Sensor (RPS) Specifications
    Specification ...

    If the engine stalls at a crossroad or crossing
    If the engine stalls at a crossroad or crossing, set the shift lever in the N (Neutral) position and then push the vehicle to a safe place. ...

    Categories

    Hyundai Equus Manuals

    © 2011-2025 Copyright www.heqmanual.com