>
Hyundai Equus Manuals

Hyundai Equus: Purge Control Solenoid Valve (PCSV) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Purge Control Solenoid Valve (PCSV) Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Purge Control Solenoid Valve (PCSV) Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the purge control solenoid valve connector (A).
3.
Disconnect the vapor hose (B) from the purge control solenoid valve.
4.
Remove the valve after removing the bolt (C).

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Be sure not to apply oil or lubricant to the end of the hoses when connecting the PCSV hose.
   
•
Use care to keep foreign material out of the valve.
1.
Install in the reverse order of removal.
Purge control solenoid valve bracket installation bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
    Purge Control Solenoid Valve (PCSV) Schematic Diagrams
    Circuit Diagram ...

    CVVT Oil Control Valve (OCV) Description and Operation
    Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by ...

    See also:

    Door Scuff Trim Repair procedures
    Replacement [Front Door Scuff Trim]     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with pro ...

    Front Rear Parking Assist System Switch Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the crash pad lower panel and then push t ...

    Oil Pump Repair procedures
    Removal 1. Remove the sub frame. (Refer to SS group) 2. Drain engine oil. (1) Remove the oil filler cap. (2) After lifting the car, remove the oil drain plug and drain oil into a conta ...

    Categories

    Hyundai Equus Manuals

    2011-2026 Copyright www.heqmanual.com