>
Hyundai Equus Manuals

Hyundai Equus: Assist Door Module (ADM) Description and Operation - Body Network System - Body Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Assist Door Module (ADM) Description and Operation

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Body Network System / Assist Door Module (ADM) Description and Operation

Description
1.
Assist Door Module (ADM)
(1)
Main features
Item
Explanation
Notes
Installation location
 Passenger side door trim

Component configuration
1.
Embedded with CAN Communication IC
2.
Embedded with LIN Communication IC
3.
Embedded with Door Lock/Unlock IC

Main features
1.
Power window controlled via passenger side power window switch
2.
Outside mirror folding/unfolding via B_CAN signal from DDM Start
3.
Manually adjust outside mirror via DDM manual switch control signal received via CAN (up, down, left, right)
4.
Save and recall mirror position via memory switch > 2 drivers
5.
Outside mirror control (auto) synchronized with the reverse gear signal
-
Outside mirror is automatically adjusted downward by 5 degrees when reverse gear signal is received
6.
Puddle Lamp & Pocket LED control through DDM signal received via CAN
7.
Door Lock/Unlock with signal from DDM via B_CAN
8.
CAN Communication (BCM CAN Communication Module)
9.
LIN Communication


(2)
For detail information about circuit diagram, refer to the power window switch.
(Refer to Power Windows - "Power Window Switch")
    Assist Door Module (ADM) Components and Components Location
    Component ...

    Rear Left Door Module (RLDM) Components and Components Location
    Component ...

    See also:

    If engine turns over normally but does not start
    1. Check fuel level. 2. With the Engine Start/Stop Button in the OFF position, check all connectors at ignition coils and spark plugs. Reconnect any that may be disconnected or loose. 3. If the en ...

    Fuel Pressure Control Valve Repair procedures
    Inspection 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the fuel pressure regulator valve connector. 3. Measure resistance between the fuel ...

    Intake Actuator Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com