>
Hyundai Equus: Knee Airbag (KAB) Module Repair procedures
| Removal |
| 1. |
Disconnect the battery negative cable and wait for at least three minutes before beginning work. |
| 2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel") |
| 3. |
Remove the knee airbag (C) after loosening the srcrews (A) and nuts (B).
|
| Installation |
| 1. |
Turn the ignition switch OFF. |
| 2. |
Disconnect the battery negative cable and wait for at least three minutes. |
| 3. |
Tighten the knee airbag mounting screws (A) and nuts (B).
|
| 4. |
Install the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel") |
| 5. |
Reconnect the battery negative cable. |
| 6. |
After installing the knee airbag, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off. |
Knee Airbag (KAB) Module Components and Components Location
Airbag Module Disposal Description and OperationSmart key precautions
The smart key will not work if any of the following occur:
- The smart key is close to a radio transmitter such as a radio station or an
airport which can interfere with normal operation of th ...
Heated Oxygen Sensor (HO2S) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 3 and 4.
4.
Check that the resistance is within the speci ...
Rear Glass Defogger Timer Repair procedures
Inspection
While operating the components, check whether the operations are normal as shown in the timing chart.
1.
Once ALT "L" is ON, if the defogger is switched ON, the defogger will stay ON f ...