>

Hyundai Equus: Fuel Tank Pressure Sensor (FTPS) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Fuel Tank Pressure Sensor (FTPS) Repair procedures

Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.

Specification: Refer to "Specification"

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the fuel pump service cover (A).

3.
Disconnect the fuel tank pressure sensor connector (A).
4.
Remove the fuel tank pressure sensor after remove the installation botl (B).

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
   
•
Insert the sensor in the installation hole and be careful not to damage when installation.
1.
Install in the reverse order of removal.
    Fuel Tank Pressure Sensor (FTPS) Schematic Diagrams
    Circuit Diagram ...

    Injector Description and Operation
    Description Based on information from various sensors, the ECM can calculate the fuel amount to be injected. The fuel injector is a solenoid-operated valve and the fuel injection amount is cont ...

    See also:

    Rear Left Door Module (RLDM) Description and Operation
    Description 1. Rear Left Power Window Switch (1) Main features ItemExplanationInstallation location Rear Left Door TrimComponent configuration 1. Embedded with LIN Communication IC 2. ...

    Components and Components Location
    Components 1. Steering Gear Box2. EHPS Motor ...

    Front Seat Belt Pretensioner Components and Components Location
    Component Location 1. Front seat belt pretensioner ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com