Hyundai Equus: Fuel Pressure Control Valve Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Fuel Pressure Control Valve Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Fuel Pressure Control Valve Description and Operation
| Description |
Fuel Pressure Control Valve is installed on the high pressure
fuel pump and controls fuel flow flowing into the injectors in
accordance with the ECM signal calculated based on various engine
condition.
CVVT Oil Control Valve (OCV) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV terminals 1 and 2.
4.
Check that the resistance is within the specifi ...
Fuel Pressure Control Valve Specifications
Specification
ItemSpecificationCoil Resistance (x)0.47 ~ 0.51 [20°C(68°F)]
...
See also:
Rear Hub - Carrier Repair procedures
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from rear hub .
Be care ...
Alternator Description and Operation
Description
The Alternator has eight built-in diodes, each rectifying AC current to DC current.
Therefore, DC current appears at alternator "B" terminal.
In addition, the charging voltage of this ...
Rear Differential Carrier Repair procedures
Replacement
1.
Drain off oil from Rear differential carrier.
2.
Remove the propeller shaft.
(Refer to Propeller Shaft Assembly - "Propeller Shaft")
3.
Remove the rear drive shaft.
(Re ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com