>

Hyundai Equus: Front Seat Shield Outer Cover Repair procedures - Front Seat - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Front Seat Shield Outer Cover Repair procedures

Replacement
[Front Seat Front Shield Outer Cover]
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Using a screwdriver or remover, remove the front seat front shield outer cover (A).

2.
Disconnect the power seat air lumber support switch connector (A).

3.
Install in the reverse order of removal.
   
•
Make sure the connector is connected properly.
•
Replace any damage clips.
[Front Seat Rear Shield Outer Cover]
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the front seat front shield outer cover.
(Refer to Front Seat - "Front Seat Shield Outer Cover")
2.
Remove the front seat lower protector (A).

3.
After loosening the mounting screw, then remove the front seat rear shield outer cover (A).

4.
Install in the reverse order of removal.
   
•
Replace any damage clips.
    Front Seat Shield Outer Cover Components and Components Location
    Component Location 1. Front seat front shield outer cover2. Front seat rear shield outer cover ...

    Front Seat Shield Inner Cover Components and Components Location
    Component Location 1. Front seat shield inner cover ...

    See also:

    Engine coolant
    The high-pressure cooling system has a reservoir filled with year-round antifreeze coolant. The reservoir is filled at the factory. Check the antifreeze protection and coolant level at least once a ...

    Specifications
    Specification Ignition System Ignition Coil ItemSpecification Primary Coil Resistance (x)0.62 ± 10% [20°C (68°F)]Secondary Coil Resistance (kx)7.0 ± 15% [20°C (68°F)] Spark Plug ...

    Brake Pedal Components and Components Location
    Components 1. Brake pedal member assembly2. Stop lamp switch3. Clevis pin 4. Snap pin5. Brake pedal 6. Return spring7. Bolt ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com