Hyundai Equus: Front Impact Sensor (FIS) Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) Description and Operation
| Description |
The front impact sensor (FIS) is installed in the Front End
Module (FEM). They are remote sensors that detect acceleration due to a
collision at its mounting location. The primary purpose of the Front
Impact Sensor (FIS) is to provide an indication of a collision. The
Front Impact Sensor (FIS) sends acceleration data to the SRSCM.
SRS Control Module (SRSCM) Repair procedures
Removal
1.
Turn the engine OFF.
2.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
3.
Remove the floor console assembly.
(Refer to Body - ...
Front Impact Sensor (FIS) Components and Components Location
Components
...
See also:
Front Door Module Repair procedures
Replacement
1.
Remove the front door window glass.
(Refer to Front Door - "Front Door Window Glass")
2.
Remove the front door outside handle.
(Refer to Front Door - "Front Door Outside Hand ...
4&OD Clutch Control Solenoid Valve Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
GAW (Gross axle weight)
This is the total weight placed on each axle (front and rear) - including vehicle
curb weight and all payload. ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com