>
Hyundai Equus Manuals

Hyundai Equus: ETC (Electronic Throttle Control) System Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: ETC (Electronic Throttle Control) System Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Engine Control System / ETC (Electronic Throttle Control) System Repair procedures

Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
Throttle angle(°)
Output Voltage (V)
TPS1
TPS2
C.T
0.5
4.5
W.O.T
4.41
0.59

ETC Motor
1.
Turn the ignition switch OFF.
2.
Disconnect the ETC module connector.
3.
Measure resistance between the ETC module terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the resonator and the air intake hose (Refer to “Intake And Exhaust System” in EM group).
3.
Disconnect the ETC module connector (A).
4.
Remove the installation bolts (B), and then remove the ETC module (C) from the engine.

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Install in the reverse order of removal.
Electronic throttle body Installation bolt:
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)
Adjustment
ETC module learning procedure
When installing new ETC module or re-installing it, ETC module learning procedure must be performed.
1.
Hold the ignition key or the start button at th IG ON position during 5 seconds.
2.
Turn ignition swich OFF and then start the engine.
   
DTC codes (P0638, P2110) might be displayed if ETC module learning procedure does not performed after replacing ETC module.
    ETC (Electronic Throttle Control) System Schematic Diagrams
    Circuit Diagram ...

    Manifold Absolute Pressure Sensor (MAPS) Description and Operation
    Description Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog si ...

    See also:

    Tire chains
    Tire chains, if necessary, should be installed on the drive wheels (rear wheels). Be sure that the chains are installed in accordance with the manufacturer's instructions. To minimize tire and c ...

    Owner maintenance precautions
    Improper or incomplete service may result in problems. This section gives instructions only for the maintenance items that are easy to perform. As explained earlier in this section, several procedu ...

    Rocking the vehicle
    If it is necessary to rock the vehicle to free it from snow, sand, or mud, first turn the steering wheel right and left to clear the area around your front wheels. Then, shift back and forth betwe ...

    Categories

    Hyundai Equus Manuals

    2011-2026 Copyright www.heqmanual.com