>
Hyundai Equus Manuals

Hyundai Equus: Trunk Lid Key Holder Repair procedures - Trunk Lid - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Trunk Lid Key Holder Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Trunk Lid / Trunk Lid Key Holder Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
1.
Remove the trunk lid trim.
(Refer to Trunk Lid - "Trunk Lid Trim")
2.
Loosen the trunk lid key holder mounting bolts.
3.
Disconnect the trunk lid key holder cable (A) and remove the trunk lid key holder (B).
Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

4.
Install in the reverse order of removal.
   
•
Make sure the trunk lid locks/unlocks and opens/closes properly.
•
Replace any damaged clips.
    Trunk Lid Latch Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply pr ...

    Trunk Lid Back Panel Components and Components Location
    Component Location 1. Trunk lid back panel ...

    See also:

    Oil Pressure Switch Repair procedures
    Inspection 1. Check the continuity between the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch. 2. Check the continuity between the terminal ...

    Schematic Diagrams
    Schematic Diagram Canister Canister is filled with charcoal and absorbs evaporated vapor in fuel tank. The gathered fuel vapor in canister is drawn into the intake manifold by the ECM/PCM when ...

    Propeller Shaft Components and Components Location
    Components 1. Propeller shaft2. Center bearing bracket ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com