>
Inspection |
1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable |
2. |
Remove the crash pad side cover. |
3. |
Remove the lower panel.
(Refer to Body - "Crash Pad") |
4. |
Remove the lower crash pad switch assembly by using the scraper and then disconnect the connectors. |
5. |
Check the continuity between the switch terminals as the ESP OFF switch is engaged. |
Recommended SAE viscosity number
CAUTION
Always be sure to clean the area around any filler plug, drain plug, or dipstick
before checking or draining any lubricant. This is especially important in dusty
or sandy areas and when t ...
G Sensor Schematic Diagrams
Circuit diagram
1.
G-sensor connector
2.
G-sensor terminal function
NoFunction1Signal2Ground3Power(5V)
3.
Circuit diagram ...
Rear Bumper Beam Assembly Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply prote ...