Hyundai Equus: Curtain Airbag (CAB) Module Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Restraint / Airbag Module / Curtain Airbag (CAB) Module Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Restraint / Airbag Module / Curtain Airbag (CAB) Module Repair procedures
| Removal |
| 1. |
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. |
| 2. |
Remove the roof trim assembly.
(Refer to Body - "Roof Trim Assembly") |
| 3. |
Disconnect the curtain airbag harness connector.
|
| 4. |
After loosening the mounting bolts remove the curtain airbag.
|
| Installation |
| 1. |
Turn the ignition switch OFF. |
| 2. |
Disconnect the battery negative cable and wait for at least three minutes. |
| 3. |
Tighten the curtain airbag mounting bolts.
|
| 4. |
Connect the curtain airbag connector. |
| 5. |
Install the roof trim assembly.
(Refer to Body - "Roof Trim Assembly") |
| 6. |
Reconnect the battery negative cable. |
| 7. |
After installing the curtain airbag (CAB), confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off. |
Knee Airbag (KAB) Module Description and Operation
Description
The Knee Airbag (KAB) is installed inside the crash pad lower
panel and protects the driver in the event of a frontal crash. The
SRSCM determines if and when to deploy the KAB.
...
See also:
Air Quality Sensor (AQS) Description and Operation
Desciption
The Air Quality Sensor (AQS) is located at the center support
in front of the engine radiator. It detects hazardous elements in
ambient air providing output signal to the control.
A ...
Schematic Diagrams
Circuit Diagram
...
Assist Handle Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply p ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com