>
Hyundai Equus Manuals

Hyundai Equus: Front Impact Sensor (FIS) Repair procedures - SRSCM - Restraint - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Front Impact Sensor (FIS) Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) Repair procedures

Removal
   
•
Removal of the airbag must be performed according to the precautions/ procedures described previously.
•
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the radiator assembly.
(Refer to Engine Mechanical System - "Radiator")
3.
Disconnect the front impact sensor connector (A), and them loosen the nuts to remove the front impact sensor (B).
[Driver's side]

[Passenger's side]

Installation
   
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Install a new front impact sensor.
2.
Tighten the front impact sensor mounting nut.
Tightening torque :
8.0 ~ 10.0 N.m (0.82 ~ 1.02 kgf.m, 5.9 ~ 7.4 lb-ft)
3.
Connect the front impact sensor connector.
4.
Install the radiator assembly.
5.
Reconnect the battery negative cable.
6.
After installing the front impact sensor, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off.
    Front Impact Sensor (FIS) Components and Components Location
    Components ...

    Side Impact Sensor (SIS) Description and Operation
    Description The Side Impact Sensor (SIS) system consists of two kinds of side impact sensor which are installed at each center of the front door module (left and right) and two rear sensors whi ...

    See also:

    Troubleshooting
    Troubleshooting SymptomPossible causeRemedyOne lamp does not light(all exterior)Bulb or LED burned outReplace bulb or lamp assemblySocket, wiring or ground faultyRepair if necessaryHead lamps do ...

    8LR Brake Control Solenoid Valve Description and Operation
    Description 8LR Brake control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 8LR Brake. ...

    Components and Components Location
    Components 1. Driver Airbag (DAB)2. Steering Wheel3. Clock Spring4. Seat Belt Pretensioner (BPT)5. Front Side Impact Sensor (FSIS)6. Side Airbag (SAB)7. Passenger Airbag (PAB)8. Front Impact Sens ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com