Hyundai Equus: Power Steering Hose Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Steering System / Electro Hydraulic Power Steering / Power Steering Hose Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Steering System / Electro Hydraulic Power Steering / Power Steering Hose Repair procedures
| Replacement |
| - |
Refer to the components illustration during removal or installation. |
| - |
When installing, be sure to connect between hose to tube using a clamp as shown in the illustration.
|
| - |
Check all clamps for deterioration or deformation; replace with the clamps new one if necessary. |
| - |
Add the recommended power steering fluid and bleed the power steering system. |
Power Steering Gear Box Repair procedures
Replacement
1.
Drain the power steering fluid.
2.
Remove the front wheel & tire.
Tightening torque :
90.0 ~ 110.0 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 80.0 lb-ft)
3.
Loosen the bolt (A) ...
Power Steering Motor Components and Components Location
Components
1. Oil reservoir2. Gear pump3. Motor4. ECU
...
See also:
ON/OFF Solenoid Valve Description and Operation
Description
ON/OFF solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. ...
Master Cylinder Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the cover.
3.
Disconnect the ECM connector (A) and TCM connector (B). And then take the protect ...
Components and Components Location
Component Location
1. Rear curtain2. Rear curtain switch (Floor console upper cover)3. Body Control Module (BCM)4. Rear seat curtain switch5. Rear door curtain6. Rear door module
...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com