>

Hyundai Equus: ON/OFF Solenoid Valve Description and Operation - Automatic Transmission Control System - Automatic Transmission System (SBC) - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: ON/OFF Solenoid Valve Description and Operation

Description
ON/OFF solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears.

    Damper Clutch Control Solenoid Valve Repair procedures
    Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the resi ...

    ON/OFF Solenoid Valve Specifications
    Specifications ON/OFF Solenoid Valve x Control type : Normal low type Control pressure kpa (kgf/cmx, psi)539.36(5.5, 78.23) Internal resistance(x)10~11 ...

    See also:

    Smart Key Unit Schematic Diagrams
    Circuit Diagram ...

    Rear Upper Arm Repair procedures
    Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)     Х Be careful not to damage t ...

    Checking the power steering fluid level
    With the vehicle on level ground, check the fluid level in the power steering reservoir periodically. The fluid should be between MAX and MIN marks on the side of the gauge at the normal tempe ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com