>

Hyundai Equus: ECU Repair procedures - Air Suspension System - Suspension System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: ECU Repair procedures

Removal
   
•
Avoid suffering excessive impact.
•
Do not entering the water into pin inside.
•
Do not pile up the parts.
•
Take care not to damage the pin of connecting portion of connector.
1.
Remove the transverse trim.
(Refer to Body - "Trunk lid")
2.
Remove the luggage side trim.
(Refer to Body - "Trunk lid")
3.
Remove the connector, bolt, nut by then remove the ECU.

4.
Installation is the reverse of removal.
Inspection

    ECU Schematic Diagrams
    Circuit diagram 1. ECU Connector 2. ECU Terminal function TerminalFunction1Ground2Ground3IGN4Battery5Battery6-7-8-9-10-11-12Reverse Valve 1x(M1 Low Side)13Ambiance Valve14Reverse Valve 2x( ...

    Height Sensor Components and Components Location
    Components Front Height Sensor 1. Lever2. Braket3. Braket4. Height sensor5. Road Rear Height Sensor 1. Lever2. Height sensor3. Road4. Braket ...

    See also:

    Battery saver function
    The purpose of this feature is to prevent the battery from being discharged. The system automatically turns off the parking lights when the driver turns off the engine and opens the driver-si ...

    Components and Components Location
    Components Location 1. Fuel tank2. Fuel pump3. Sub fuel sender4. Fuel filter5. Over Pressure Valve (OPV)6. Canister7. Fuel tank air filter8. Fuel Pressure Sensor (FPS)9. Fuel Level Sensor ( ...

    Steering Wheel Remote Controller (SWRC) Troubleshooting
    Initialization and Troubleshooting Procedures 1. Initialization Procedure : Disconnect (connector or battery) for 30 seconds (time required for internal condenser discharge), then reconnect the p ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com