Hyundai Equus: Damper Clutch Control Solenoid Valve Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Damper Clutch Control Solenoid Valve Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Damper Clutch Control Solenoid Valve Repair procedures
| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Disconnect the E Module connector. |
| 3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
| 4. |
Check that the resistance is within the specification. |
Damper Clutch Control Solenoid Valve Schematic Diagrams
Circuit Diagram
...
ON/OFF Solenoid Valve Description and Operation
Description
ON/OFF solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. ...
See also:
Keep paint and trim in good condition
Scratches or chips in the finish should be covered with "touch-up" paint as soon
as possible to reduce the possibility of corrosion. If bare metal is showing through,
the attention of a ...
Driver's and passenger's front air bag
Your vehicle is equipped with a Supplemental Restraint (Air Bag) System and the
lap/shoulder belts at both the driver and passenger seating positions.
The indications of the system's presence ...
Repair procedures
Inspection
Front Door Lock Module Inspection
1.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
2.
Remove the front door module.
(Refer to Body - "Front Door Module")
3.
...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com