Hyundai Equus: Line Pressure Control Solenoid Vale Repair procedures
Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Line Pressure Control Solenoid Vale Repair procedures
Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Line Pressure Control Solenoid Vale Repair procedures
| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Disconnect the E Module connector. |
| 3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
| 4. |
Check that the resistance is within the specification. |
Line Pressure Control Solenoid Vale Schematic Diagrams
Circuit Diagram
...
Damper Clutch Control Solenoid Valve Description and Operation
Description
Damper Clutch control solenoid valve is attached to the valve
body. This variable force solenoid valve directly controls the
hydraulic pressure inside the Damper Clutch. ...
See also:
Multi-view Camera Switch Repair procedures
Removal
Floor Console Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the floor console upper cover.
(Refer to Body - "Floor Console Assembly")
3.
Disconnect the consol ...
Rear Seat Assembly Repair procedures
Replacement
[Rear Seat Cushion Assembly]
1.
Pull it up and remove the rear seat cushion assembly (A).
2.
Install in the reverse order of removal.
•
Make sure the ...
Power Latch Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the trunk trim in the trunk.
(Refer to Body - "Trunk")
3.
Remove the power latch (A) after removing the bolts (2EA) and ...
Categories
Hyundai Equus Manuals
© 2011-2025 Copyright www.heqmanual.com