Hyundai Equus: Automatic Transmission Components and Components Location
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission System / Automatic Transmission Components and Components Location
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission System / Automatic Transmission Components and Components Location
| Components Location |
| 1. Automatic transmission case 2. Inhibitor switch 3. Manual control lever 4. Shift cable bracket 5. Oil injection hole 6. Air breather hose & pipe | 7. Oil injection hole (in factory) 8. E Module connector 9. Support bracket 10. Check plug 11. Oil cooler port |
Repair procedures
EOL Input
Description
When shift shock is occurred or parts related with the transmission are replaced, EOL should be performed.
In the following case, EOL is required.
•
Transmission ass ...
Automatic Transmission Repair procedures
Removal
1.
Disconnect (-) terminal from the battery.
The battery is placed right side of the temporary tire in the trunk.
2.
Remove the under cover (A).
3.
Remove ...
See also:
General Information
General
1.
Basically, all measurements in this manual are taken with a tracking gauge.
2.
When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
3.
...
Windows
(1) Driver’s Door Power Window Switch
(2) Front Passenger’s Door Power Window Switch
(3) Rear Door (left) Power Window Switch and Curtain Switch (if equipped)
(4) Rear Door (right) Power Wind ...
Cylinder Block Components and Components Location
Components
1. Cylinder block bank cover2. Cylinder block bank cover gasket3. Cylinder block rear cover4. Cylinder block rear cover gasket5. Separator6. Drain plug7. O-ring8. Piston oil jet9. Chec ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com