>
Hyundai Equus: Fuel Sender Assembly Repair procedures
| Removal |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
| 2. |
"Release the residual pressure in fuel line.
(Refer to Fuel Delivery System -""Release Residual Pressure in Fuel Line"")" |
| 3. |
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump") |
| 4. |
Disconnect the fuel pump & sender ground (A).
|
| 5. |
Disconnect the fuel pump connector & fuel sender connector (A). |
| 6. |
Lift the fixing hook (B) by using a common driver, and then remove the fuel sender (C).
|
| Installation |
| 1. |
Install in the reverse order of removal. |
Fuel Pump Motor Repair procedures
Over Pressure Valve (OPV) Repair proceduresReprogramming a single HomeLink® button
To program a new device to a previously trained HomeLink® button, follow these
steps:
1. Press and hold the desired HomeLink® button. Do NOT release until step 4 has
been completed.
2. When th ...
Consumer information
This consumer information has been prepared in accordance with regulations issued
by the National Highway Traffic Safety Administration of the U.S. Department of
Transportation.
Your EQUUS dealer ...
Steering Column Shroud Panel Components and Components Location
Component Location
1. Steering column shroud lower panel2. Steering column shroud upper panel
...