>
Hyundai Equus Manuals

Hyundai Equus: Purge Control Solenoid Valve (PCSV) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Purge Control Solenoid Valve (PCSV) Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Purge Control Solenoid Valve (PCSV) Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the purge control solenoid valve connector (A).
3.
Disconnect the vapor hose (B) from the purge control solenoid valve.
4.
Remove the valve after removing the bolt (C).

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Be sure not to apply oil or lubricant to the end of the hoses when connecting the PCSV hose.
   
•
Use care to keep foreign material out of the valve.
1.
Install in the reverse order of removal.
Purge control solenoid valve bracket installation bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
    Purge Control Solenoid Valve (PCSV) Schematic Diagrams
    Circuit Diagram ...

    CVVT Oil Control Valve (OCV) Description and Operation
    Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by ...

    See also:

    Height Sensor Schematic Diagrams
    Circuit diagram 1. Height sensor connector 2. Height sensor terminal function TerminalFunction1Height Sensor Ground2-3-4-5Height Sensor Power 6Height Sensor Signal 3. Circuit diagram ...

    Overhead Console Lamp Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the overhead console lamp (A) after loosening the overhead console lamp screw(2EA). 3. Disconnect the sunroof switch conn ...

    Ignition Coil Specifications
    Specification ItemSpecification Primary Coil Resistance (x)0.62 ± 10% [20°C (68°F)]Secondary Coil Resistance (kx)7.0 ± 15% [20°C (68°F)] ...

    Categories

    Hyundai Equus Manuals

    2011-2026 Copyright www.heqmanual.com