Hyundai Equus: Rail Pressure Sensor (RPS) Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Rail Pressure Sensor (RPS) Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Rail Pressure Sensor (RPS) Description and Operation
| Description |
Rail Pressure Sensor (RPS) is installed on the delivery pipe
and measures the instantaneous fuel pressure in the delivery pipe. The
sensing element (Semiconductor element) built in the sensor converts the
pressure to voltage signal. By using this signal, the ECM can control
correct injection amount and timing and adjusts the fuel pressure with
the fuel pressure regulator valve if the target pressure and the actual
pressure calculated by the RPS output signal are different.
Accelerator Position Sensor (APS) Repair procedures
Inspection
1.
Connect a scantool on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
Specification: Refe ...
Rail Pressure Sensor (RPS) Specifications
Specification
...
See also:
Head Up Display ON/OFF
To activate the head up display, press the HUD button.
If you press the HUD button again, the head up display will be deactivated. ...
Mic Repair procedures
Removal
1.
Remove the hands free mic (A) from the roof trim.
Installation
1.
Install the hands free mic after connecting the mic connector.
Inspection
1.
Remove the handsfree mic (A) aft ...
Removable towing hook (if equipped)
1.Open the trunk, and remove the towing hook from the tool case.
2.Remove the hole cover by pressing the lower part of the cover on the front
or rear bumper.
3.Install the towing hook by turning ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com