Hyundai Equus: Knock Sensor (KS) Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Knock Sensor (KS) Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Knock Sensor (KS) Repair procedures
| Removal |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
| 2. |
Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group). |
| 3. |
Disconnect the knock sensor connector (A).
[Bank 1]
[Bank 2]
|
| 4. |
Remove the cross over fuel pipe (A).
|
| 5. |
Remove the installation bolt (A), and then remove the sensor from the cylinder block.
|
| Installation |
|
| 1. |
Install in the reverse order of removal.
|
Knock Sensor (KS) Schematic Diagrams
Circuit Diagram
...
Heated Oxygen Sensor (HO2S) Description and Operation
Description
Heated Oxygen Sensor (HO2S) consists of zirconium and alumina
and is installed both upstream and downstream of the Manifold Catalytic
Converter. The sensor output voltage varies in ...
See also:
Center Fascia Panel Components and Components Location
Component Location
1. Center fascia upper panel2. Center fascia lower panel
...
Delivery Pipe Repair procedures
Removal
In case of removing the high pressure fuel pump, high
pressure fuel pipe, delivery pipe, and injector, there may be injury
caused by leakage of the high pressure f ...
Troubleshooting
Troubleshooting
Problem Symptoms Table
Before replacing or repairing air conditioning components,
first determine if the malfunction is due to the refrigerant charge, air
flow or compressor. ...
Categories
Hyundai Equus Manuals
2011-2026 Copyright www.heqmanual.com