>
Hyundai Equus: Engine Coolant Temperature Sensor (ECTS) Repair procedures
| Inspection |
| 1. |
Turn the ignition switch OFF. |
| 2. |
Remove the ECTS (Refer to "Removal"). |
| 3. |
After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 1 and 2. |
| 4. |
Check that the resistance is within the specification.
|
| Removal |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
| 2. |
Disconnect the engine coolant temperature sensor connector (A), and then remove the engine coolant temperature sensor (B).
|
| 3. |
Supplement the engine coolant (Refer to “Cooling System” in EM group).
|
| Installation |
|
|
|
| 1. |
Install in the reverse order of removal.
|
Engine Coolant Temperature Sensor (ECTS) Schematic Diagrams
Crankshaft Position Sensor (CKPS) Description and OperationCrach Pad Center Panel Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply p ...
Rear Differential Carrier Repair procedures
Replacement
1.
Drain off oil from Rear differential carrier.
2.
Remove the propeller shaft.
(Refer to Propeller Shaft Assembly - "Propeller Shaft")
3.
Remove the rear drive shaft.
(Re ...
Center Fascia Panel Components and Components Location
Component Location
1. Center fascia upper panel2. Center fascia lower panel
...