>

Hyundai Equus: Crankshaft Position Sensor (CKPS) Description and Operation - Engine Control System - Engine Control/Fuel System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Crankshaft Position Sensor (CKPS) Description and Operation

Description
Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the engine may stop because of CKPS signal missing.
This sensor is installed in ladder frame and generates alternating current by magnetic flux field which is made by the sensor and the target wheel when the engine rotates. The target wheel consists of 58 slots and 2 missing slots on 360 CA (Crank Angle).

    Engine Coolant Temperature Sensor (ECTS) Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Remove the ECTS (Refer to "Removal"). 3. After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECT ...

    Crankshaft Position Sensor (CKPS) Specifications
    Specification ItemSpecificationCoil Resistance (x)774 ~ 946 [20°C (68°F)]Air cap(mm)0.5 ~ 1.5 ...

    See also:

    Front Hub / Knuckle / Tone Wheel Repair procedures
    Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from front hub .     Be ca ...

    Description and Operation
    Description Active type ECS is applied and it includes the self leveling function.As shown in the picture, it consists of air spring, damper, reservoir tank, compressor (with dryer), solenoid ...

    Telemetics Unit (TMU) Components and Components Location
    Component Connector Pin Information No.DescriptionNo.Description1Ground17Battery 22Ground18Battery 13-19IGN 14Keypad ground20ACC5MIC output -21Airbag6MIC output +22Keypad input7-23-8RS422 shie ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com